
Release Notes for CradlePoint Rev 5.2.2 Firmware
New features added in this release (Not all features are in all
products – see their respective Data Sheets):
CradlePoint Secure Connect (CPSC) Port Forwarding. A CPSC tunnel can now be added to
a zone for Port Forwarding traffic from the tunnel. The Zone NAT rules can be created for
any source zone to specify destination Port Forwarding similar to the existing WAN Port
Forwarding Rules. However unlike existing WAN Port Forwarding Rules, Zone NAT rules
apply to all traffic from the source zone to any destination IP not just to traffic for the WAN IP
destination.
(IBR6x0P only) Smart Operator Selection. When this feature is enabled and when used with
a globally-provisioned SIM, the router scans for available mobile broadband networks then
selects the best network based on user-configurable values.
Additional UI/Usability changes:
Network Settings, Content Filter. The Rule Priority column can now be used for sorting.
System Settings -> Administration -> Local Management -> System Identifier. The filter
on this was too strict and wouldn’t allow certain ASCII characters. It has been changed
to allow for all ASCII characters.
Internet -> VPN Tunnels Pre-Shared Key. A filter was added to restrict the PSK to a too-
strict subset of ASCII characters. This filter was changed to allow printable ASCII
characters.
Network Settings -> Wi-Fi -> Local Networks. Changing Channel Selection method and
refreshing the screen would cause Wi-Fi settings to show as blank.
Internet-> Connection Manager-> Edit-> General Settings. Added configurable retry
settings to IPv4 Failure Check. Default values are those recommended by CradlePoint
for best Internet connectivity.
Defects fixed:
Zone Firewall GRE filtering was fixed
IPS Add/Removal of Signatures to the whitelist might fail was fixed
(IBR600/IBR650) GPIO Output not switching value with Modem Connected was fixed
Wired WAN (Ethernet), Active DNS doesn’t failover was fixed
(MC400xxx only) When the modem encounters a link down connection, the modem now
correctly reports it is not connected.
Known issues:
IPSec. Certificates do not work if Router Services used (new feature in 5.2.0)
Komentáře k této Příručce